Welcome Visitor, you can login or create an account

EDMMax 656W Fast Wire EDM


or call 888-BUY-EDMS (289-3367)


EDMMax - Affordable Fast wire solution for most wire EDM applications. These full 4 axis wire EDMs use .007'' diameter molybdenum high tensile wire. That is "reusable". It is cycled back and forth from a capstan continuously, until it is replaced with a new load of wire, ≈ 200 meters. This low cost moly wire lasts approximately 48 ours of continuous cutting, depending on the application, and the total cost of the operation is about $1.00/hour.


The fast wire EDM comes complete with an on-board CAD System, plus you can download programs via USB. It has taper capability +1-3° and dialectic filtration system using disposable paper filters.

  • Fast Wire EDM Cutting in Terrible Flush Conditions

  • Fast Wire EDM

  • AddUp 3D Part Cutoff


Unlike conventional brass wire EDMs, the Fast Wire EDMs are not "flush dependent." They do not require high pressure flush or submerged cutting to reduce wire breakage. Instead, we use an additive to the deionized water that allows the water to adhere to the moly wire, thus allowing it to be drawn through the narrow kerf, to remove the EDM swarf, without breaking the wire! This feature makes it ideal for removing the 3D LPBF (Laser Powder Bed Fusion) printed parts from the build plates. These Fast Wire EDMs will typically cut 2-3 times faster than brass wire EDMs in interrupted conditions.


EDMMax 434WEDMMax 656WEDMMax 1800W
X 400mm (15.7") 630mm (24.8") 1000mm (39.4")
Y 320mm (12.6") 500mm (19.7") 800mm (31.5")
Z - Max Clearance 410mm (16.14") 625mm (24.6") 1050mm (41.3")
U-V Taper +1-3° +1-3° +1-3°
Max Workpiece
Weight 600kg (1320lbs) 1000kg (2220lbs) 2000kg (4400lbs)
Resolution .001mm .001mm .001mm
X-Y Drives - Panasonic AC Servo Motors
On Board CAD System
Industrial PC. W/ Mouse
Remote Control
USB Port

We appreciate your interest in EDM Network Inc.,
a representative will contact you.