EDMMax FC65HW (Horizontal, Submerged) Fast Wire EDM

This unique inverted, submerged cutting, Fast Wire EDM was designed to rapidly remove the 3-D metal printed parts from the build plates. The FC models were designed to run with reusable molybdenum wire, travelling back and forth between two spoolers at about 5 meters/second. The fast-moving wire draws the EDM swarf out of the cut area quickly to increase forward cutting speed. Fast Wire EDMs are perfect for the interrupted cutting of 3-D metal printed parts as the fast-moving wire does bit require high pressure water for speed.

This unique, inverted, Fast Wire EDM features:

• Submerged cutting
• Reusable .007" or .008"molybdenum (moly) wire
• Pure water - no water additive required
• Faster cutting than moly wire EDM
• AC and DC switchable power supplies
• Easy part recovery
• Automated build plate loading (optional)
• Zero-point clamping to assure accuracy
• Alignment of wire to build plate
• Tension control by servo motor
• Fast changing of new wire (approx. 250 meters)
• The FC models do not require the water additive of other moly fast wires as the work areas and water reservoir is stainless steel.
• Part retrieval is simple with the drop front door design. Manual loading, or an optional loading cart is available.
• The FC models cut with the build plate inverted so that upon cutoff, the individual parts separate and float to the bottom of the work tank for easy retrieval.
• The FC models are stainless steel design and, therefore, only require deionized water without the additive used by other Fast Wire EDMs, eliminating the secondary cleaning operation.
• Manual loading or optional build plate cart loading for heavier build plates up to 176 lbs.

Price includes on-site installation and training.

Photos included are of the FC45HW.

Installation and On-site Training are included.